Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Jeep
    3. :
  3. Compass
    4. : How to replace the rear light bulb on a Jeep Compass

Jeep Compass - Video tutorial

Model: Jeep Compass MK 49, MK 1 - Years 2006-2016
Part: Rear light bulb
Operation: How to replace the rear light bulb on a Jeep Compass

Before starting, we will have to open the tailgate of our Jeep Compass. So let's start by unhooking and removing the clips that secure the rear light to the car. After that, we will have to unhook the internal hooks. By doing so, we will have freed the rear light itself. We then proceed by going to extract the light from its seat, to then disengage and remove the base of the burned out bulb. At this point, we will have reached the burnt out bulb, which we will have to disengage and remove, and the disassembly will be completed. To fit the new bulb, we will just have to follow these steps in reverse, and we will have completed the replacement.


Posted on 7 February 2024 by ScegliAuto



Jeep Compass headlight bulb replacement
Jeep Compass (2016-2024 / 552, MK 2) Today we will see how to remove and replace the headlight bulb of a Jeep Compass. First of all, let's remove the mudguard screws from the affected si
How to replace the headlight bulb on a Jeep Compass
Jeep Compass (2006-2016 / MK 49, MK 1) Before we can begin, we will have to go and open the front hood of our Jeep Compass. So let's start by disconnecting the electrical connector connect
How do you replace the parking light bulb on the Jeep Compass?
Jeep Compass (2016-2024 / 552, MK 2) In order to replace the position lights bulb of the Jeep Compass, you need to loosen the screws that secure the inner cover of the corresponding whee

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos