Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Jeep
    3. :
  3. Cherokee
    4. : How to reset the oil change light on the Jeep Cherokee

Jeep Cherokee - Video tutorial

Model: Jeep Cherokee MK 5, KL - Years 2013-2023
Part: -board computer
Operation: How to reset the oil change light on the Jeep Cherokee

Resetting the Jeep Cherokee oil change light is a routine operation that must be performed after every oil and oil filter change. In this way, the sensor present is forced to perform a new reading which will make the alarm light disappear definitively. To do this, you must make sure you start the procedure with the car completely turned off. Then press the "Start" button three consecutive times and do the same with the accelerator pedal as well. At this point the warning light has been reset successfully and you can switch off the ignition or proceed with driving.


Posted on 10 April 2024 by ScegliAuto



Resetting the oil change (service) warning light on the Jeep Cherokee (2018)
Jeep Cherokee (2013-2023 / MK 5, KL) Today we will see the instructions needed to reset the oil change routine maintenance service light on the 2018 5th Generation Jeep Cherokee. First o
How to do oil change reset on Jeep Cherokee
Jeep Cherokee (2013-2023 / MK 5, KL) In this video tutorial, we can see how to reset the oil change light on Jeep Cherokee. The first thing to do will therefore be to change the engine o
How to reset the oil warning light on the Jeep Cherokee
Jeep Cherokee (2008-2012 / KK, MK 4) Resetting the oil warning light on the 2010 Jeep Cherokee is very simple and takes just a few seconds to complete the entire operation correctly. Let

    Frequently Asked Questions

    • Cherokee 2013-2023 - Why doesn't the Jeep Cherokee Start&Stop system work? Read Answer

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos