Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Wiring the Reverse Camera on a Jeep Renegade

Model: Jeep Renegade MK 1, BU, 520 - Years: 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025
Part: Parking sensors

Video tutorial

To install the rear camera, you need to remove the complete trim around the air vents that surrounds the touch display. Unscrew the 4 screws securing the Uconnect display, pull it out, and disconnect the power connector.

Take the camera kit and position the wiring between the 54-pin connector and the display. Take the 30-pin connector and, before connecting it to the interface, configure the dip switches by setting dip 3 and 4 of the 12-pin series to 'ON' and all pins of the 5-pin series to 'OFF', and set the rotary switch to '9'. Connect the connector to the interface, then open the door, turn on the ignition, wait for the display to start, and confirm by pressing 'accept'. Set dip 2 on the 5-pin series to 'ON' to activate the camera coding procedure; once completed, the display will restart.

Confirm on the touch screen and check the camera input activation by engaging reverse (before connecting the camera), then turn off the ignition. Connect the reverse camera power supply (cable included with the camera), then connect the camera to the interface input.

Reassemble the display and trim, turn on the ignition, engage reverse, and check that the camera image is visible.


Updated on 14 May 2026 by ScegliAuto


Related tutorials

Replacing the Rear Camera on a Jeep Renegade
Replacing the Rear Camera on a Jeep Renegade
Jeep Renegade (2014-2026 / MK 1, BU, 520) Open the boot lid and remove the internal cover of the boot lid: to do this, unscrew all the screws that secure it and detach it by hand, first pulli…
Replacing the Cabin Air Filter on the 2018 Jeep Renegade
Replacing the Cabin Air Filter on the 2018 Jeep Renegade
Jeep Renegade (2014-2021 / ) In this video, you will see how to replace the cabin air filter on your Jeep Renegade and, in some cases, eliminate the annoying noises you hear when…
How to Remove the Fog and Reverse Lights in the Jeep Renegade
How to Remove the Fog and Reverse Lights in the Jeep Renegade
Jeep Renegade (2014-2026 / MK 1, BU, 520) In this video, you will learn how to replace the reverse and fog lights in the successful small SUV from the American manufacturer, the Jeep Renegade…

How to Remove the Toll Tag Holder from the Car Windscreen

The toll tag holder is usually attached to the car windscreen to ensure that the toll tag functions immediately when passing through barriers. However, if you decide to remove the holder, you should follow this procedure: - Insert the toll tag into the holder; - Pull the holder inwards to detach it from the windscreen; you can use a glass scraper or a stiff plastic card to assist you; After removing the holder, it is essential to remove the adhesive from the windscreen. To remove the adhesive, we recommend using a solvent-based spray that will remove the glue without clouding the area.

Watch the video!


by ScegliAuto

More videos