Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Reset the Start&Stop System on the Jeep Compass?

Model: Jeep Compass MK 1, MK 49 - Years 2006-2016
Part: Warning light – error code

To reset the Start&Stop system on the Jeep Compass, open the bonnet to access the battery located in the engine compartment. The Start&Stop system activates automatically, and no procedure is needed to operate it. To reset the system, disconnect the connector located at the bottom of the battery, then reconnect it after a few seconds. Once reconnected, you can verify that the system has been reset.

Updated on 20 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to restore the operation of the start&stop system of the Jeep Compass
How to restore the operation of the start&stop system of the Jeep Compass
Jeep Compass (2016-2025 / 552, MK 2) In this short and simple guide, we will see how to reset the start&stop system of the Jeep Compass, following the instructions below. In order for th…
How to Disable the Start&Stop System on the Jeep Compass
How to Disable the Start&Stop System on the Jeep Compass
Jeep Compass (2016-2025 / 552, MK 2) Today we will discover the instructions that will allow us to enable and disable the Start&Stop system on the Jeep Compass, in simple steps. First, l…
How to Permanently Disable Start/Stop in the Jeep Compass?
How to Permanently Disable Start/Stop in the Jeep Compass?
Jeep Compass (2016-2025 / 552, MK 2) This video shows how to permanently disable Start/Stop in the Jeep Compass. Start/Stop is a system that helps slightly reduce fuel consumption by aut…

Other guides you may be interested in

    Frequently Asked Questions

    • Compass 2016-2025 - What does the "RPM x1000" light indicate in the Jeep Compass? Read answer
    • Compass 2006-2016 - Why does the start and stop light come on in a Jeep Compass? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos