Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Jeep
    3. :
  3. Cherokee
    4. : Jeep Cherokee headlight bulb replacement

Jeep Cherokee - Video tutorial

Model: Jeep Cherokee MK 5, KL - Years 2013-2023
Part: Headlight bulb
Operation: Jeep Cherokee headlight bulb replacement

Let's see how to replace the headlight bulb in a Jeep Cherokee. First, rotate the front wheel corresponding to the light in which the lamp to be changed is housed. Inside the wheel arch, in the front part, there is a cap that we will remove by rotating it ninety degrees: we will thus have access to the rear part of the headlight, protected by a second cap. Proceeding with caution, given that access is not easy, also remove this cap, disconnect and remove the old bulb. Insert the new bulb paying attention to the correct positioning, connect the power cable and close the two caps. Finally, we verify that it works correctly.


Posted on 13 May 2023 by ScegliAuto



How to replace the headlight bulb on the Jeep Cherokee?
Jeep Cherokee (2013-2023 / MK 5, KL) In order to replace the Jeep Cherokee headlight bulbs, you need to lift the hood and remove the air filter to access the right bulb and the battery t
Replacement of the front headlight bulb of the Jeep Cherokee
Jeep Cherokee (2013-2023 / MK 5, KL) Today's step-by-step instructions will allow us to disassemble and replace the headlight bulb of the Jeep Cherokee. First, let's move to the side and
Jeep Cherokee headlight bulb replacement
Jeep Cherokee (2013-2023 / MK 5, KL) Today we will see how to remove and replace the headlight bulb of a fourth series Jeep Cherokee, in simple steps. First we go to unscrew the screws o

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos