Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Fitting a Load Bed Cover

Model: Jeep Wrangler MK 3, JK - Years 2007-2018
Part: Body

As a first step, call a friend under the pretext of offering them a coffee, as you will need an extra pair of hands for this task. Open the rear window of the load bed cover to avoid breaking it. Next, start placing the cover on the edge of the load bed, ensuring that the two edges align, especially at the holes where you will need to secure the bolts found by lifting the panel located on the floor of your boot. Then proceed to secure the various bolts, connect any plugs and pipes, and you're done!

Updated on 24 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Remove the Key Battery on Jeep Wrangler
Remove the Key Battery on Jeep Wrangler
Jeep Wrangler (2007-2018 / MK 3, JK) Is the Jeep Wrangler key battery dead and needs changing? Here’s how to remove it from inside the key. Take your remote key, and with the help of a s…
How to replace the radio in the Jeep Wrangler?
How to replace the radio in the Jeep Wrangler?
Jeep Wrangler (2007-2018 / MK 3, JK) Today, we will see how to replace the radio in the Jeep Wrangler. To perform the radio replacement, we need to remove the upper dashboard cover using…
How to Change a Wheel on Your Car
How to Change a Wheel on Your Car
Jeep Wrangler (2007-2018 / MK 3, JK) Start by opening the boot and lifting the panel that covers the wheel change kit. Next, remove the wheel cover located on the rear of the car and uns…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos