Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Kia
    3. :
  3. Picanto
    4. : Engine oil and filter replacement

Kia Picanto - Video tutorial

Model: Kia Picanto MK 1, 2A - Years 2004-2011
Part: Oil filter
Operation: Engine oil and filter replacement

Place a basin immediately under the oil pan and unscrew the drain plug located at the rear; once the drain is finished, screw the cap; the oil filter is located in front of the oil pan, immediately under the exhaust manifold: use a metal clamp or chain wrench to unscrew it; sprinkle the gasket of the new filter with clean oil and screw it in without exceeding the tightening torque. Finally, fill the engine with clean oil up to the maximum level. After a few kilometers, check the level again to make sure there is no abnormal consumption.


Posted on 18 August 2023 by ScegliAuto



Oil filter replacement on Kia Picanto.
Kia Picanto (2011-2018 / TA, MK 2) If we want to proceed with replacing the engine oil and filter, in the description below we have listed all the various steps necessary for a correct
Kia Picanto oil change
Kia Picanto (2004-2011 / MK 1, 2A) Let's see the replacement of the oil of a Kia Picanto and the change of the filter. We lift the car with a lifting jack, then we find the oil drain p
Where is the oil filter of the 2018 Kia Picanto?
Kia Picanto (2018-2024 / JA, MK 3) This short video explains the procedure for changing the oil on your 2018 Kia Picanto very well and also shows where the air filter is located. As yo

Other guides that may interest you

    Frequently Asked Questions

    • Picanto 2004-2011 - Where is the oil filter located in the Kia Picanto? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos