Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Rear Bumper of the Lancia Delta

Model: Lancia Delta MK 3 - Years 2008-2014
Part: Rear bumper

In today's tutorial video, you will learn how to remove the rear bumper of the third series Lancia Delta by following these simple and quick steps. First, move to the rear of your car and start by unscrewing and removing the screws located on both sides of the wheel arches using a Torx spanner; then gently detach the bumper from the sides, as shown in the video. At this point, use a socket spanner to unscrew the screws found under the bumper; finally, disconnect the electrical connector of the fog light bulb to release the bumper!

Updated on 7 May 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

Removing Front Headlights and Bumper on Lancia Delta 3
Lancia Delta (2008-2014 / MK 3) In this video tutorial, you will learn how to remove the front headlights and bumper on a third-generation Lancia Delta. First, unscrew all the faste…
How to Remove the Rear Light from a Lancia Delta
How to Remove the Rear Light from a Lancia Delta
Lancia Delta (2008-2014 / MK 3) Before you start, exit the cabin of your Lancia Delta and head to the lower rear side of the vehicle. Begin by unclipping and removing the rear light…
Removing the Front Grille of a Lancia Delta Integrale
Removing the Front Grille of a Lancia Delta Integrale
Lancia Delta (1979-1993 / MK 1) In this video tutorial, you will learn how to remove the front grille of a Lancia Delta Integrale. This operation does not require any special tools,…

Other guides you may be interested in

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos