Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Rear Bumper on the Lancia Ypsilon

Model: Lancia Ypsilon Y1, Ypsilon 1, MK 1, 840 - Years 1996-2003
Part: Rear bumper

If you need to replace the rear bumper on this vehicle because it may have been damaged in an accident, follow the instructions below and refer to the video. First, lift the vehicle on a ramp and unscrew the screws located inside the wheel arch, removing the lower splash guard first. Then, remove the rear light units using a plastic lever and gently unclip all the fastening clips of the bumper, allowing it to be removed. Finally, mount the new bumper after assembling it with the lower splash guard.

Updated on 7 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Fit a Rear Bumper on a Lancia Ypsilon
How to Fit a Rear Bumper on a Lancia Ypsilon
Lancia Ypsilon (2003-2011 / 843, MK 2, Ypsilon 2, Y2) How do you fit a rear bumper on a Lancia Ypsilon? Let's see how to proceed; it's not too complex if done methodically. First, grab the bumper and pos…
How to Remove the Rear Bumper from a Lancia Ypsilon
Lancia Ypsilon (2011-2023 / MK 3, Y3, Ypsilon 3, 846) Before you can start, open the boot of your Lancia Ypsilon. Begin by removing the rear lights by unscrewing and removing the fixing screws, then pull…
How to remove the front headlamp of a Lancia Ypsilon
How to remove the front headlamp of a Lancia Ypsilon
Lancia Ypsilon (2003-2011 / 843, MK 2, Ypsilon 2, Y2) Before you can start, open the bonnet of your Lancia Ypsilon. Begin by loosening and moving the section of the front bumper near the headlamp, unscre…

Other guides you may be interested in

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos