Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Where to Find the OBD2 Port of the Range Rover Evoque

Model: Land Rover Evoque MK 1, L538 - Years: 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018
Part: Checks and maintenance

See other generations:
Video tutorial

To find the OBD2 port of your first-generation Range Rover Evoque, follow the procedure described below. First, make sure the vehicle is completely turned off before you begin, then go to the driver's seat and focus on the lower part of the dashboard.

At this point, locate the OBD2 port you were looking for, and the procedure is complete without any difficulty. If needed, you can connect a diagnostic tool to analyze all the data recorded by the vehicle's control unit.


Posted on 28 October 2026 by ScegliAuto


Related tutorials

Where is the VIN located on the Range Rover Evoque?
Where is the VIN located on the Range Rover Evoque?
Land Rover Evoque (2018-2026 / L551, MK 2) In this video we see where the VIN number is located on the Range Rover Evoque: We can find it inside the trunk, under the carpet near the backrest o…
Replacing the Key Fob Battery for Land Rover Range Rover Evoque
Replacing the Key Fob Battery for Land Rover Range Rover Evoque
Land Rover Evoque (2011-2018 / MK 1, L538) In this video, you will see how to disassemble and replace the battery of the key fob for a Land Rover Range Rover Sport, as well as the standard Ran…
Where to Find the Fuse Box in a Range Rover Evoque
Where to Find the Fuse Box in a Range Rover Evoque
Land Rover Evoque (2011-2018 / MK 1, L538) To locate the fuse box in your first-generation Range Rover Evoque (2011-2018), carefully follow the instructions in this new guide. First, ensure th…

Other guides you may be interested in

How to Remove the Rear Hatch Cover of the Mercedes B-Class

In this video, you will learn how to remove the rear hatch cover of the Mercedes B-Class. You will need a small flathead screwdriver to remove the handle cover. Use long-nosed pliers to gently remove the clips inside. The next step is to carefully insert a plastic spatula into the gap created to start removing the cover; it is advisable to start from the sides and work towards the centre. Disconnect the courtesy light connector, and continue gently removing the plastics by leveraging the gaps created, always starting from the sides. Be cautious of clips and wiring, and handle everything with care.

Watch the video!


by ScegliAuto

More videos