Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Front Suspension Drop Link

Model: Lexus IS MK 2 - Years 2005-2013
Part: Anti-roll bar

The failure of the drop link (slang term for stabiliser link) connecting the stabiliser bar to the suspension wishbone is quite common, but replacing it is straightforward. Lift the vehicle on the lift and remove the front wheel to increase working space. Use a hex key to hold the drop link's shaft while you undo the securing nut, from both the stabiliser bar side and the wishbone side. Once the old drop link is removed, install the new one in the same way (it is advisable to replace both).

Updated on 18 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Stabiliser Bar Bush Replacement
Stabiliser Bar Bush Replacement
Lexus IS (2005-2013 / MK 2) If you hear a squeaking noise from the rear stabiliser bar, it is likely that the supporting bushes are damaged. To replace them, lift the vehicle on…
Replacing the Rear Drop Link
Replacing the Rear Drop Link
Lexus IS (2005-2013 / MK 2) If you hear a noise similar to a knocking sound coming from the rear suspension, it is likely that the drop link connecting the rear stabiliser bar t…
Anti-Roll Bar Bush Replacement
Anti-Roll Bar Bush Replacement
Lexus IS (2005-2013 / MK 2) If you hear a noise similar to a thump while driving over uneven surfaces, it is likely that the support bushes of the stabiliser bar have failed. Ev…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos