Do it yourself
Frequently asked questions about cars and motorcycles

Model: Malaguti Grizzly
Part: Shocks

To replace the front shock absorber of the Malaguti Grizzly, you first need to remove the corresponding front wheel: to remove it, you will need to loosen the nuts that secure its central axle and also loosen the screws that attach the brake caliper to the corresponding disc. Once the wheel has been removed, you can take off the fork by loosening the screws that secure it from the top: at this point, it will be possible to slide out the shock absorber from the bottom so that it can be replaced with a new spare part.

Posted on 14 December 2025 by ScegliAuto

Video tutorial

Related tutorials

Grizzly To remove the fork on a Malaguti Grizzly, position the bike on a stand and loosen the nut that secures the front wheel spindle. Once this is removed,…
Grizzly Discover how to change the engine oil on the Malaguti Grizzly 10 scooter by following the instructions below. First, locate the engine oil drain bolt…
Grizzly To remove the engine block from the frame of the Malaguti Grizzly, first disconnect the carburettor attached to it, along with the other cables, and …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos