Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mazda
    3. :
  3. 3
    4. : How to remove the rear light of a Mazda 3

Mazda 3 - Video tutorial

Model: Mazda 3 MK 2, BL - Years 2009-2013
Part: Tail light
Operation: How to remove the rear light of a Mazda 3

How do you remove the rear light of a Mazda 3? Let's see the disassembly of the lighthouse. We raise the boot of the luggage compartment, then, we remove the cloth cap covering the side of the luggage compartment. We unscrew the metal nuts that tighten the rear light; disconnect the power supply terminals connected to the headlight and pull it away from the bodywork. We replace damaged bulbs with new ones (same voltage) on hand. We reassemble the lighthouse with the respective power supply terminals, with tightening nuts; we reassemble the inspection cap and test the correct functioning of the lights.


Posted on 26 November 2023 by ScegliAuto



How to disassemble the rear light of the Mazda 3
Mazda 3 (2009-2013 / MK 2, BL) Today we will see, in this video tutorial, how to remove and replace the rear light and its bulbs of the Mazda 3. First we open the tailgate of the t
How to replace the rear light bulbs du Mazda 3
Mazda 3 (2009-2013 / MK 2, BL) We change the burnt out bulbs inside the luggage compartment which gives access to the rear light of a Mazda 3. With a screwdriver we remove the plas
How to replace the rear light bulbs on a Mazda 3
Mazda 3 (2009-2013 / MK 2, BL) Are the rear light bulbs gone? Let's see how to change them. Let's open the tailgate, let's put it in safety. We detach the fabric panel that covers

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos