Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mazda
    3. :
  3. 3
    4. : How to change the spark plugs on Mazda 3

Mazda 3 - Video tutorial

Model: Mazda 3 MK 3, BN, BM - Years 2013-2019
Part: Spark plugs
Operation: How to change the spark plugs on Mazda 3

Let's see how to change the damaged spark plugs mounted on a Mazda 3. We open the engine compartment and lift the front hood, let's put it in safety. We remove the engine soundproofing panel by unscrewing the tightening screws. We unscrew the screws on the sides of the coils with a wrench or screwdriver, remove the coils on the motor head (we disconnect the power supply terminals). We unscrew the candles with a socket wrench, take them out of the head. We fit the spark plugs with the socket wrench extension into the cylinder head, tighten them and connect the power coils to each spark plug. We mount the soundproofing panel of the engine. We turn on and verify the operation.


Posted on 7 December 2023 by ScegliAuto



How to replace the spark plugs on a Mazda 3
Mazda 3 (2003-2009 / BK, MK 1) Before we can start, we will have to go to open the front hood of our Mazda 3. So let's start by disassembling and removing the air filter block, uns
How to change the oil, oil filter and spark plugs on a Mazda 3
Mazda 3 (2003-2009 / BK, MK 1) We see in this video how to change the oil, oil filter and spark plugs on a Mazda 3. The Mazda 3 is boxed in the lower part, so we have to remove the
How to replace the spark plugs of the Mazda 3
Mazda 3 (2009-2013 / MK 2, BL) How to disassemble damaged spark plugs? Let's see how the spark plugs are removed from inside the engine compartment of a Mazda 3. We lift the front

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos