Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Side Indicator Bulb

Model: Mazda 6 GG, MK 1 - Years 2002-2008
Part: Side marker bulb

To easily remove the protective cap of the bulb holder for the left front headlamp, it is necessary to remove the air filter container: first disconnect the mass air sensor connector and the rear hose connected to it; then pull the air filter container upwards to disengage and remove it (it is secured with rubber grommets). At this point, you can disengage the bulb holder cap, extract the bulb holder without disconnecting the power connector, and remove the bulb (T5 fitting) and insert the new one; reattach the bulb holder and then the cap. Proceed in reverse to reassemble the air filter container.

Updated on 7 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Indicator Bulb
How to Replace the Front Indicator Bulb
Mazda 6 (2002-2008 / GG, MK 1) Open the bonnet of the engine compartment. Using a suitable screwdriver, unscrew the screw located at the top edge of the headlamp, on the outer side…
Front Headlight Bulb Replacement
Mazda 6 (2002-2008 / GG, MK 1) To access the front headlight bulb, it is necessary to remove the wheel and the corresponding plastic wheel arch: once removed, you can take off the …
Replacing Xenon Headlight Bulb on Mazda 6
Replacing Xenon Headlight Bulb on Mazda 6
Mazda 6 (2002-2008 / GG, MK 1) In this video tutorial, you will learn how to remove the headlight bulb from a Mazda 6. The bulb is located behind the front wheel, so disconnect the…

How to reset the tyre pressure warning light on the Suzuki Jimny?

To reset the tyre pressure warning light on the Suzuki Jimny, first inflate the tyres to the pressure value indicated on the corresponding sticker: this is located at the bottom of the driver's door pillar. Once the tyres are inflated, insert the ignition key and turn on the instrument panel: select the screen that indicates the tyre pressures, checking that the values change. After a few seconds, the tyre pressure warning light will automatically turn off.

Watch the video!


by ScegliAuto

More videos