Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Rear Brake Pads of the Mazda CX-5

Model: Mazda CX-5 MK 1, KE - Years 2012-2017
Part: Brake pads

Today, in this video tutorial, learn how to remove and replace the rear brake pads of the Mazda CX-5 in simple and quick steps. First, lift the vehicle and remove the rear wheel; then, unscrew the screws securing the brake caliper by removing the screws found at the back, as illustrated in the video. Now, lever inside the caliper to retract the piston, thus removing the old pads; clean the caliper of dirt and install the new, high-quality pads. Finally, reassemble everything!

Updated on 18 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing Brake Pads on a Mazda CX-5
Replacing Brake Pads on a Mazda CX-5
Mazda CX-5 (2012-2017 / MK 1, KE) Are the brake pads worn out? Let's see how to remove them from inside the brake caliper. Lift the car on a column lift, then remove the wheel (using …
How to Replace the Front Brake Pads on the Mazda CX-5
How to Replace the Front Brake Pads on the Mazda CX-5
Mazda CX-5 (2012-2017 / MK 1, KE) Follow these instructions to remove and replace the front brake pads on the Mazda CX-5. First, lift the vehicle and remove the front wheel; then, und…
How to Replace the Front Brake Pads on a Mazda CX-5
How to Replace the Front Brake Pads on a Mazda CX-5
Mazda CX-5 (2012-2017 / MK 1, KE) This guide shows how to replace the front brake pads on a Mazda CX-5 Mk1. The first step is to loosen the wheel bolts on the side you are working on;…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos