Do it yourself
Frequently asked questions about cars and motorcycles

How to Remove the Rear Bumper on a Mazda 6

Model: Mazda 6 GH, MK 2 - Years 2008-2012
Part: Rear bumper

The following steps will guide you in removing and replacing the rear bumper on a Mazda 6. First, open the boot lid and start unscrewing and removing the clips and screws found above the rear bumper. Then, unscrew all the screws located on both sides of the wheel arches, as shown in the video. At this point, also remove the rear lights by disconnecting the electrical connectors, and gently detach the bumper from the sides until it is completely removed!

Updated on 14 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Mazda 6 (2008-2012 / GH, MK 2) .. In this tutorial, you will see how to remove the rear bumper on a Mazda 6, a very simple and quick operation. First, open the boot,.. …
Mazda 6 (2002-2008 / GG, MK 1) Open the rear hatch; unclip the retaining clips that connect the wheel arches to the bumper edge; unscrew the bumper fixing screw to the rear wing (l…
Mazda 6 (2002-2008 / GG, MK 1) Do you want to replace the front bumper of a Mazda 6? Let's see how to proceed. Lift the bonnet and secure it. Using a plastic spatula or screwdriver…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos