Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Rear Bumper on a Mazda 6?

Model: Mazda 6 GH, MK 2 - Years 2008-2012
Part: Rear bumper

In this tutorial, you will see how to remove the rear bumper on a Mazda 6, a very simple and quick operation. First, open the boot, then remove the caps located at the back of both tail lights and, using a socket spanner, unscrew the fixing bolts. Once the lights are separated from the bodywork, continue by unscrewing the released bolts, those located inside the wheel arches, and removing the rivets on the lower edge of the bumper. Finally, grasp the bumper at one end and unclip it from the frame.

Updated on 22 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Rear Bumper on a Mazda 6
How to Remove the Rear Bumper on a Mazda 6
Mazda 6 (2008-2012 / GH, MK 2) The following steps will guide you in removing and replacing the rear bumper on a Mazda 6. First, open the boot lid and start unscrewing and removing…
How to Replace the Front Bumper on the Mazda 6?
How to Replace the Front Bumper on the Mazda 6?
Mazda 6 (2002-2008 / GG, MK 1) In this tutorial, you will see how to replace the front bumper on the Mazda 6, a very simple and quick operation. First, open the bonnet, then using …
Replacing the Horn
Replacing the Horn
Mazda 6 (2002-2008 / GG, MK 1) Open and lift the bonnet and disconnect the negative terminal from the battery. Next, remove the bolts securing the front bumper, both at the top and…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos