Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Mazda
  4. :
  5. 3
  6. : How to replace the fuel filter in the Mazda 3?

Mazda 3 - Video tutorial

Model: Mazda 3 BK, MK 1 - Years 2003-2009
Part: Diesel filter
Operation: How to replace the fuel filter in the Mazda 3?

In this tutorial, we can see how to replace the fuel filter in the Mazda 3, an extremely simple and fast operation. First of all, we wait for the engine to be completely cold, then we open the hood, locate the filter on the passenger side, and unscrew the two nuts of the mounting bracket. We then disconnect both the indicated tubes and the sensor connector, remove the housing from the engine compartment, and unscrew the filter from the support. At this point, all that remains is to tighten the replacement and reassemble everything following the reverse procedure.


Posted on 19 September 2023 by ScegliAuto



How to change the fuel filter on Mazda 3
Mazda 3 (2003-2009 / BK, MK 1) Let's see how to remove and replace the fuel filter on Mazda 3. We lift the car on a column bridge (jack), we identify the fuel filter near the rear
How to replace the fuel filter in the Mazda 3?
Mazda 3 (2009-2013 / MK 2, BL) .. In this tutorial, we can see how to replace the fuel filter in the Mazda 3, a very simple and cost-effective operation. Let's start..
How to replace the fuel filter in Mazda 3?
Mazda 3 (2009-2013 / MK 2, BL) In this tutorial we can see how to replace the fuel filter in your Mazda 3, a very simple operation. Before proceeding, make sure the engine is compl

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos