Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Mercedes
  4. :
  5. Sl
  6. : How to close or open the soft top on Mercedes SL 560

Mercedes Sl - Video tutorial

Model: Mercedes Sl MK 5, R129 - Years 1989-2001
Part: Soft top
Operation: How to close or open the soft top on Mercedes SL 560

Let's see in this video how to close or open the soft top on a Mercedes SL 560, first series, following the instructions below. First of all, let's go and remove the fixing pins of the hood, which we find above the sun visors, with the special key; after that, once the hood has been unhooked from the front, we are going to remove it from the side, as shown in the video. At this point we are going to insert it in its compartment, opening the side uprights; we just have to close them again by turning the side lever. To put the top back on, just apply the reverse procedure!


Posted on 27 January 2024 by ScegliAuto



How do you remove the soft top of the Mercedes SL?
Mercedes Sl (2011-2021 / R231, MK 7) In order to remove the soft top of the Mercedes SL you have to lift the latter and open the tailgate, in order to access the luggage compartment. Her
Manual hood closing instructions
Mercedes Sl (1989-2001 / MK 5, R129) If the soft top has to be closed and hooked in manual mode, it is first of all necessary to have the appropriate standard key in the tool set: it is
Removing the soft top control piston
Mercedes Sl (1989-2001 / MK 5, R129) In order to remove the hydraulic piston that controls the soft top opening and closing system, you must first have the special key to release the sof

    Frequently Asked Questions

    • Sl 1989-2001 - How much does the key to release the soft top cost for Mercedes Sl r129? Read Answer
    • Sl 1989-2001 - Which keys to use to unlock the Mercedes w129 soft top? Read Answer

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos