Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe C
    4. : Removing the passenger side airbag on Mercedes C-Class

Mercedes Classe C - Video tutorial

Model: Mercedes Classe C W204 - Years 2007-2013
Part: Airbags
Operation: Removing the passenger side airbag on Mercedes C-Class

First, for safety reasons, disconnect the battery: to do this, always start by disconnecting the negative pole and only then switch to the positive. Move the upper door seal and then the relevant panel, as shown in the video. Now, to get to the airbag you will first have to perform two simple steps: removing the glove box and the switch for the airbag itself. Also remove the air duct in the upper part of the compartment, then go to the upper area of the central dashboard and disconnect the connectors, then remove the entire central tunnel. Lastly, remove the speedometer and you will be able to remove the entire front dashboard and access the airbag.


Posted on 2 February 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Classe C 2007-2013 - What does the malfunction of the restraint system indicate, in the Mercedes C-Class W204? Read Answer
    • Classe C 2007-2013 - What does the message "front right - fault" mean with the airbag warning light in the Mercedes C-Class? Read Answer
    • Classe C 2000-2007 - Why did the "SRS" warning light come on in the Mercedes C-Class? Read Answer
    • Classe C 2000-2007 - SRS fault restraint warning light, what does it mean? Read Answer
    • Classe C 2007-2013 - How to turn off SRS warning light on Mercedes C-Class? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos