Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe A
    4. : How do you replace the Mercedes A-Class drive shaft boot?

Mercedes Classe A - Video tutorial

Model: Mercedes Classe A W169 - Years 2004-2012
Part: Drive shaft boot
Operation: How do you replace the Mercedes A-Class drive shaft boot?

In order to replace the drive shaft boot of the Mercedes A-Class you have to go and lift the car using a jack or a bridge, so that the corresponding wheel is not in contact with the floor. Then you will have to loosen the screws that fix the wheel, completely removing the latter and accessing the parts in the rear area of the hub. Here it will be possible to unscrew the screws that secure the hub to the remaining parts of the front suspension, so that the drive shaft is released. Once the wheel has been moved, the old drive shaft boot can be removed so that a new one can be inserted.


Posted on 4 May 2024 by ScegliAuto



How to replace the gear knob of the Mercedes A-Class.
Mercedes Classe A (1997-2004 / W168) Let's briefly see in this guide how to disassemble and replace the gear knob of the Mercedes A-Class. First of all, we get in the car and start by re
How do you replace the gear knob on the Mercedes A-Class?
Mercedes Classe A (2004-2012 / W169) In order to replace the Mercedes A-Class gear knob, you have to unhook the clips at the base of the knob's leather boot, so that it can be completely
How do you replace the axle boot on a Mercedes A-Class?
Mercedes Classe A (2004-2012 / W169) The replacement of the Mercedes Classe A axle boot is done by lifting the car with a jack or a lift, so that the bolts securing the corresponding fro

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos