Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

What is the relay panel diagram for the Mercedes A-Class?

Model: Mercedes Classe A W176 - Years 2012-2018
Part: Fuse box

The relay panel of the vehicle is located under the passenger side floor (under the dashboard) next to the fuse box in the cabin. Below is the diagram and corresponding list: A Relay circuit 15R (2) (SA); B Relay circuit 15R (1); C Horn relay; D Rear window defroster relay; E Wiper relay stage 1/2; F Wiper on/off relay; G Relay circuit 15 (1); H Emergency relay; I Air pump relay; K Fuel pump relay; L Engine circuit relay 87; M Starter relay; N Relay circuit 87F; O Relay circuit 15 (2) (SA: xenon, cell phone).

Updated on 18 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Where is the fuel pump relay located in the Mercedes A-Class?
Where is the fuel pump relay located in the Mercedes A-Class?
Mercedes Classe A (2004-2012 / W169) .. If the fuel pump in the Mercedes A-Class W169 fails, you can check the status of the corresponding relay and replace it for a small cost.. …
Fuse position and diagram of the Mercedes A-Class
Fuse position and diagram of the Mercedes A-Class
Mercedes Classe A (2004-2012 / W169) .. and the fuse diagram of the Mercedes A-Class. First, we open the front passenger door and start removing the floor mat and plastic cover; inside.. …
What is the fuse diagram for the Mercedes A-Class?
Mercedes Classe A (2012-2018 / W176) .. corresponding fuse diagram for the Mercedes A-Class W176, useful if you need to check a fuse after the failure of one or more devices. As you can see,.. …

Other guides you may be interested in

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos