Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe C
    4. : Replacing the tappet cover gasket

Mercedes Classe C - Video tutorial

Model: Mercedes Classe C W202 - Years 1993-2000
Part: Engine
Operation: Replacing the tappet cover gasket

Before applying the new gasket to the cover, tapping, it is essential to carefully clean the gasket seat, both on the head side and under the cover, in order to eliminate any residual dirt and encrustation that could alter adherence and therefore the seal. of the gasket. Once the cleaning phase is complete, insert the gasket inside the groove along the edges of the cover and in correspondence with the central area (injectors seat); once the gaskets are in place, position the cover and tighten the fixing pins; then apply the new gaskets to the bottom of the injectors and install them by inserting them in the center of the tappet cover.


Posted on 6 August 2023 by ScegliAuto

    Frequently Asked Questions

    • Classe C 2007-2013 - What engine does the Mercedes C-Class have? Read Answer
    • Classe C 2014-2021 - What problems does the engine of the Mercedes C-Class present? Read Answer
    • Classe C 2014-2021 - What problems does the engine of the Mercedes C220 CDi have? Read Answer
    • Classe C 2014-2021 - What is the cost of maintenance service B on the Mercedes C-Class? Read Answer
    • Classe C 2007-2013 - What role does the crankshaft position sensor play? Read Answer
    • Classe C 2000-2007 - How much does it cost to redo the engine of the Mercedes C220? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos