Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe B
    4. : Removing the Mercedes B-Class fan resistor

Mercedes Classe B - Video tutorial

Model: Mercedes Classe B MK 1, W245 - Years 2005-2011
Operation: Removing the Mercedes B-Class fan resistor

Let's find out in this short and simple guide how to remove and replace the resistor of the passenger compartment fan of the Mercedes B-Class, but also of the A-Class. First we get on board the car and start by removing the plastic panel, which we find on the lower left part of the pedal board; after which we go to extract the resistor of the passenger compartment fan, together with its wiring, as shown in the video. At this point we disconnect the connector to replace the fan resistance, subsequently verifying the operation of our air conditioner.


Posted on 24 September 2022 by ScegliAuto

    Frequently Asked Questions

    • Classe B 2019-2026 - What happens in case of malfunction of the restraint system on the Mercedes Class B? Read Answer
    • Classe B 2011-2019 - What does the message "Go to the workshop without changing gear" mean in the Mercedes B-Class? Read Answer
    • Classe B 2011-2019 - What are the most common problems in a Mercedes B-Class W246? Read Answer
    • Classe B 2011-2019 - What starting problems can a Mercedes B-Class have? Read Answer
    • Classe B 2011-2019 - What is the position of the crankshaft sensor on the Mercedes B-Class? Read Answer
    • Classe B 2019-2026 - What is the cost of the service for the Mercedes B-Class? Read Answer
    • Classe B 2019-2026 - What problems are there with the Mercedes B-Class w247? Read Answer
    • Classe B 2005-2011 - How often should the Mercedes B-Class W245 be serviced? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos