Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Sprinter
    4. : Wheel hub cover logo application

Mercedes Sprinter - Video tutorial

Model: Mercedes Sprinter MK 2, W906 - Years 2006-2018
Part: Accessory Kit
Operation: Wheel hub cover logo application

To apply the frieze in the center of the plastic cup on the rim, it is first of all necessary to carefully clean the seat of the frieze by removing any residual dirt that could compromise the adhesion of the double-sided adhesive: it is recommended to use alcohol or industrial degreaser; once cleaning is complete, remove the film from the double-sided adhesive on the back of the frieze, position it in the center of the plastic cup and press until it adheres perfectly; therefore remove the transparent protective film applied to the front of the frieze to prevent scratches.


Posted on 13 August 2023 by ScegliAuto



How to replace the wheel on Mercedes Sprinter
Mercedes Sprinter (2006-2018 / MK 2, W906) How to replace a damaged wheel with a spare on a Mercedes Sprinter? Let's see how to proceed: let's take the wheel removal kit which includes: jack,
How to remove the ABS rpm sensor on Mercedes Sprinter
Mercedes Sprinter (1995-2006 / W901, MK 1) Let's see how to remove the brake disc and the ABS and rpm sensor. We unscrew the wheel pins with a telescopic wrench and (compressed air drill) remo
Replacement discs and front pads
Mercedes Sprinter (1995-2006 / W901, MK 1) Raise the car on a bridge and remove the front wheel; then release the pad wear sensor and pry between the disc and the pads to allow the piston to r

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos