Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Gl
    4. : Replacement discs and front pads

Mercedes Gl - Video tutorial

Model: Mercedes Gl MK 1, X164 - Years 2006-2012
Part: Brake discs
Operation: Replacement discs and front pads

Raise the car on the bridge and remove the front wheel; remove the pad support spring, the brake caliper fixing pin caps to be able to disassemble it, disconnect the wear sensor socket and extract the old pads; then disassemble the caliper support and the disc fixing screw in order to remove it from its seat; clean the disc seat on the hub with a metal brush and apply grease; then install the new disk fixing it with the relative screw and clean it of the protective oil; fit the caliper support, push the caliper piston back with the special clamp, insert the new pads, install the caliper and then the pad support spring, and then reassemble the wheel.


Posted on 31 August 2023 by ScegliAuto



How to change the front brake discs and pads on Mercedes GL
Mercedes Gl (2006-2012 / MK 1, X164) To replace the front brake discs and pads on this car model, it is advisable to lift it on a bridge and remove the front wheel; then disconnect the w
Replacement discs and rear pads
Mercedes Gl (2006-2012 / MK 1, X164) If the rear brake discs have to be replaced, it is a good idea to replace the pads as well; therefore lift the car and remove the rear wheel, release
Replacement arm of the car
Mercedes Gl (2006-2012 / MK 1, X164) If the suspension arm of our car is deformed or worn, perhaps following a collision, it must be replaced to avoid a dangerous loss of the vehicle. It

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos