Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Sprinter
    4. : Replacement discs and front pads

Mercedes Sprinter - Video tutorial

Model: Mercedes Sprinter W901, MK 1 - Years 1995-2006
Part: Brake discs
Operation: Replacement discs and front pads

Raise the car on a bridge and remove the front wheel; then release the pad wear sensor and pry between the disc and the pads to allow the piston to retract slightly; remove the protective caps from the pins fixing the caliper to the support and unscrew them to be able to remove the caliper, extract the old pads and fully retract the piston; then move on to disassembling the caliper support and the hub disc; brush the disc seat on the hub and the sliding area of the pads on the support to eliminate dirt residues and then apply grease; install the new disc after washing it to remove the protective oil, the caliper support and insert the new pads before reassembling the caliper by lubricating the relative pins.


Posted on 3 September 2023 by ScegliAuto



Replacement of brake pads and discs
Mercedes Sprinter (1995-2006 / W901, MK 1) Raise the car and secure it with the special stands. Unscrew the bolts and remove the wheel. Unscrew the two screws holding the caliper with an 18 a
Replacement of front brake pads
Mercedes Sprinter (2006-2018 / MK 2, W906) Raise the vehicle on a lift or on suitable car stands; then remove the front wheel in order to access the brake caliper and release the wear sensor c
Replacement of the front headlight bulb of the Mercedes Sprinter
Mercedes Sprinter (2006-2018 / MK 2, W906) Let's see how to change the front headlight bulb of the Mercedes Sprinter in case it has burned out. Open the engine hood and position ourselves in f

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos