Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. MG
    3. :
  3. Mg Zs
    4. : Door trim panel

MG ZS - Door trim panel

Door Trim Panel MG ZS (2017-2024 / zs 11)

MG ZS (2017-2024 / Zs11)
How to Remove the Rear Door Panel on an MG ZS
Here are the step-by-step instructions to remove and replace the rear door panel on an MG ZS, following these simple steps. First, open the rear door and start …Read all…
Posted on 10 July 2026 by ScegliAuto
MG ZS (2017-2024 / Zs11)
How to Remove the Rear Door Panel of the MG ZS?
To remove the door panel of the MG ZS, loosen the screws that secure the panel: these are located in the handle recess and under the small panel next to the …Read all…
Posted on 8 July 2026 by ScegliAuto
MG ZS (2017-2024 / Zs11)
Removing the Front Door Panel of the MG ZS
Today, in this video tutorial, you will learn how to remove and replace the front door panel of the MG ZS in simple and quick steps. First, open the front door …Read all…
Posted on 22 July 2026 by ScegliAuto
Airbag (1) Air conditioning (1) Car stereo (5) Battery (3) Spark plugs (2) Body (1) Key (15) Onboard computer (7) Checks and maintenance (13) Dashboard (1) Bearing (1) Headlight (1) Air filter (3) Cabin air filter (3) Diesel fuel filter (1) Parking brake (1) Accessory kit (2) Headlight bulb (4) Tail light bulb (2) License plate light (1) Engine (1) Engine oil (3) Clock (7) Door trim panel (3) Instrument cluster (1) Radiator (1) Wheel (1) Fuse box (18) Rearview mirror (1) (18) Service warning light (17) Fuel cap (4) Windshield wipers (4) Thermostat (1)

How to Connect the Cables to the Battery of the Citroen Xsara Picasso?

In this tutorial, you will see how to connect the cables to the battery of the Citroen Xsara Picasso, useful if you need to recharge it or perform an emergency start. First, ensure the key is not inserted, then open the bonnet and move to the front of the left headlamp. Next, locate the bolt just behind the filter box and connect the positive terminal clamp to it. Now you can connect the negative terminal to any point on the chassis, such as the indicated point. Once the operation is complete, ensure you disconnect the negative first and then the positive.

Watch the video!


by ScegliAuto

More videos