Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. MG
    3. :
  3. Mg Zs
    4. : Car stereo

MG ZS - Car stereo

MG ZS (2017-2024 / Zs11)
How to replace the factory radio of the MG ZS.
Let's see in this guide how to remove and replace the standard car radio with an Android type radio for the MG ZS, in simple and quick steps. First, we get …read all…
Posted on 29 April 2023 by ScegliAuto
MG ZS (2017-2024 / Zs11)
How do you replace the car radio on the MG ZS?
In order to replace the MG ZS car radio, you need to remove the air vent located on the right side of the dashboard, so that you can then remove all the …read all…
Posted on 10 May 2023 by ScegliAuto
MG ZS (2017-2024 / Zs11)
Replacement of the stock car radio with an Android one on the MG ZS
Let's briefly discover the steps that will allow us to disassemble and replace the stock car stereo with a new multimedia system of the Android type on the MG …read all…
Posted on 4 September 2022 by ScegliAuto
MG ZS (2017-2024 / Zs11)
How to disassemble the car stereo of the Mg Zs
Today we will see, in this video tutorial, how to disassemble and replace the car stereo of the Mg Zs, following the instructions below. First of all we get on …read all…
Posted on 21 May 2022 by ScegliAuto
Airbags (1) Car stereo (4) Battery (6) Spark plugs (2) Bodywork (1) Key (9) -board computer (1) Checks and maintenance (8) Dashboard (1) Bearing (1) Air filter (3) Cabin air filter (2) Diesel filter (1) Hand brake (1) Accessory Kit (2) Headlight bulb (2) Rear light bulb (2) Engine (1) Engine oil (2) Door panel (3) Instrument cluster (2) Radiator (1) Wheel (1) Fuse box (4) Interior rearview mirror (1) Windscreen wipers (2) Thermostat (1)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos