Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the oxygen sensor of a Mini R56

Model: Mini Mini R57, R56, R55 - Years: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014
Part: Oxygen sensor

See other generations:
Video tutorial

Let's see how to replace the oxygen sensor, also known as the "lambda sensor" on a Mini R56. Its main task is to measure the amount of oxygen present in the exhaust gases: this information is sent to the ECU, which uses it to adjust the air-fuel mixture, in order to optimize combustion, improving the engine efficiency.

We remove the front plate of the engine compartment, removing ten bolts and three clips.

Under the manifold, in a rather awkward position, we find our sensor, which must be unscrewed with a 22mm wrench and pulled away from the opposite side, also removing an electrical connector for more space.


Posted on 3 May 2025 by ScegliAuto


Related tutorials

Cleaning the MAF sensor on a Mini Cooper R56
Cleaning the MAF sensor on a Mini Cooper R56
Mini (2007-2014 / R57, R56, R55) If the Mini Cooper S shows irregular power delivery, try cleaning the MAF sensor, which may be the cause of the malfunction. Open the bonnet of the e…
Where is the oil pressure sensor located in the Mini Cooper?
Where is the oil pressure sensor located in the Mini Cooper?
Mini (2007-2014 / R57, R56, R55) In this video, you can see where the engine oil pressure sensor is located in the Mini Cooper and how to proceed if you need to replace it, a very si…
Replacing the Outside Air Temperature Sensor on the Mini Cooper
Replacing the Outside Air Temperature Sensor on the Mini Cooper
Mini (2007-2014 / R57, R56, R55) In this guide, you will see the steps that will allow you to dismantle and replace the outside air temperature sensor on the Mini Cooper. First, lift…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos