Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Rear Light of the Opel Frontera

Model: Vauxhall Frontera Frontera B, MK 2 - Years 1998-2003
Part: Tail light

To remove the rear light of the Opel Frontera, first unscrew three screws that secure the light unit in place. The screws are located two on the side of the light and one underneath the lower edge, which is somewhat difficult to reach. Once the rear light unit is removed from its position, you can separate the outer cover with the reflectors from the inner base where the various bulbs are housed. To do this, unscrew the nut that holds it in place using your fingers. If desired, disconnect the electrical supply by unplugging the appropriate connector. After this, you will have access to the various bulbs, which can be easily replaced. To reassemble the light, simply reverse the steps described.

Updated on 28 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Where is the ECU Located in the Opel Frontera?
Where is the ECU Located in the Opel Frontera?
Vauxhall Frontera (1998-2003 / Frontera B, MK 2) In this video, you can see where the ECU is located in the Opel Frontera and how to proceed if you need to replace it. As shown, it is located inside…
How to Replace the Diesel Filter on the Opel Frontera
How to Replace the Diesel Filter on the Opel Frontera
Vauxhall Frontera (1998-2003 / Frontera B, MK 2) The diesel filter on the Opel Frontera is located at the bottom of the vehicle: to access it, you will need to remove the protective panel found at t…
How to Reset the Trip Meter on the Opel Frontera?
How to Reset the Trip Meter on the Opel Frontera?
Vauxhall Frontera (1998-2003 / Frontera B, MK 2) The vehicle shown in this video is a 2001 Opel Frontera, and now we will see how to reset the trip meter. This operation is usually performed when yo…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos