Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Vauxhall
    3. :
  3. Corsa
    4. : How to mount Opel Corsa cylinder head

Vauxhall Corsa - Video tutorial

Model: Vauxhall Corsa Corsa B - Years 1993-2000
Part: Engine head
Operation: How to mount Opel Corsa cylinder head

After removing the engine of your car, do you want to reassemble the cylinder head? Let's see in this video how to assemble the cylinder head on Opel Tigra: we have to insert the camshaft into the cylinder head, lubricate it with a suitable liquid and seal the cylinder head with silicone suitable for the type of metal. We insert all the locking pins of the cylinder head in the seats. We tighten the cylinder head pins with an electronic or normal torque wrench, if we hear the crick noise of the pin that tightens the metal, we have to stop. Give the same tightening to all the pins on the cylinder head.


Posted on 19 October 2023 by ScegliAuto

    Frequently Asked Questions

    • Corsa 2014-2019 - How much does it cost to replace the cylinder head gasket in the Opel Corsa? Read Answer
    • Corsa 2014-2019 - How much does it cost to repair the cylinder head gasket on the Opel Corsa? Read Answer
    • Corsa 2006-2014 - How much does the cylinder head of the Opel Corsa D cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos