Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Vauxhall
    3. :
  3. Insigna
    4. : Stop replacement of the Insigna

Vauxhall Insigna - Video tutorial

Model: Vauxhall Insigna MK 1, Insigna A - Years 2008-2017
Part: Tail light
Operation: Stop replacement of the Insigna

Replacing the stop on an Opel Insigna. We disassemble the rear light if it is damaged or if we want to replace the bulbs. We open the tailgate of the luggage compartment and put it in safety; we open the plastic inspection cap (located in the luggage compartment) and unscrew all the screws that block the headlight. We detach the lighthouse from its housing with a lever and disconnect the power supply terminals. After removing the headlight, mount a new one in the car sheet or replace the damaged bulbs. Finally we test the correct functioning of the bulbs that we have mounted in the lighthouse. We replace damaged headlight bulbs.


Posted on 22 December 2023 by ScegliAuto

This video is currently unavailable


How to replace the diesel filter on an Opel Insigna
Vauxhall Insigna (2008-2017 / MK 1, Insigna A) Do you want to replace the diesel filter on your Opel Insigna and don't know how to do it? Let's see in this video how to proceed. We lift the car on
How to replace the key battery Opel Insigna
Vauxhall Insigna (2008-2017 / MK 1, Insigna A) Replacing the battery of the Opel Insigna remote control key is very simple to carry out above all because the entire key does not have to be disasse
How to reset the service on the Opel Insignia
Vauxhall Insigna (2008-2017 / MK 1, Insigna A) Have we changed the engine oil and filter on this car model? In addition to carrying out the replacement work, we must then proceed to reset the main

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos