Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Front Brake Pads

Model: Vauxhall Astra Astra J - Years 2009-2016
Part: Brake pads

Remove the plastic covers from the wheel bolts and undo the nuts. Open the brake fluid reservoir cap. Lift the vehicle and remove the brake caliper by taking out the two spring clips with pliers. Remove the two plastic covers and use a 7mm hex key to free the cylinder from both sides. Clean the edge of the disc and retract the cylinder. Replace the pads, taking care not to damage the position of the cylinder. Release the fluid into the piston and reposition the cylinder. Realign the piston by pushing it inwards and check the adherence of the pads to the disc. Refit the springs and check the brake fluid level, topping it up if necessary.

Updated on 8 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to fit Opel Astra brake pads
How to fit Opel Astra brake pads
Vauxhall Astra (2009-2016 / Astra J) How to replace the brake pads of the Opel Astra? Let's see the disassembly of the brake parts. We disassemble the wheel to access the brake disc, uns…
How to Replace the Front Brake Pads on the Opel Astra
How to Replace the Front Brake Pads on the Opel Astra
Vauxhall Astra (2009-2016 / Astra J) This guide explains how to replace the front brake pads on the Opel Astra model J. Start the replacement procedure by opening the front bonnet and th…
Replacement of brake pads on Opel Astra j
Replacement of brake pads on Opel Astra j
Vauxhall Astra (2009-2016 / Astra J) To get to the replacement of the front brake pads you must first remove the affected wheel by unscrewing the bolts and lifting the car with a jack. S…

Other guides you may be interested in

How to Replace the Front Headlamp Bulb on a Fiat Grande Punto

To replace the front headlamp bulb on a Fiat Grande Punto, first open the bonnet. Once done, access the rear of the headlamp where the bulb needs replacing (the bulb is of type H4). Locate the rubber cover that protects the electrical contacts and bulbs from water and moisture. Remove it by pulling on the tab. Now, pull the connector for the bulb's power supply and disconnect it from its position. At this point, push down on the top of the spring that holds the bulb in place, and you can extract the bulb from its housing. To fit the new bulb, follow the steps in reverse as shown in the images. The video also shows how to remove the position bulb, which is located just below the H4. After disconnecting the power supply, you can extract it along with the bulb holder by pressing the two tabs to release it and pulling. The bulb can then be removed from its position in the bulb holder.

Watch the video!


by ScegliAuto

More videos