Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Fan Resistor on an Opel Astra

Model: Vauxhall Astra Astra H - Years: 2004, 2005, 2006, 2007, 2008, 2009, 2010
Part: Heater control valve

See other generations:
Video tutorial

Before you begin, it is highly recommended to disconnect the battery to work safely on the electrical system. Start by removing the glove compartment.

Once the glove compartment is removed, you will notice the resistor. To remove it, press on the two side clips and then pull it out of its housing.

At this point, simply disconnect the connectors attached to it. This completes the removal. To install the new resistor, simply follow the steps in reverse, and you will have successfully completed the replacement.


Updated on 26 April 2026 by ScegliAuto


Related tutorials

How to Remove the Cabin Fan and Its Resistor on the Opel Astra G
How to Remove the Cabin Fan and Its Resistor on the Opel Astra G
Vauxhall Astra (1998-2006 / Astra G) In this video tutorial, you will find the main instructions for removing the cabin fan and its resistor on the second series Opel Astra G. First, get…
How to replace the fan resistor on an Opel Astra
How to replace the fan resistor on an Opel Astra
Vauxhall Astra (2004-2010 / Astra H) .. How to replace the fan resistor on an Opel Astra. This guide shows you how to carry out the disassembly... …
How to Replace the Cabin Fan on the Opel Astra?
How to Replace the Cabin Fan on the Opel Astra?
Vauxhall Astra (2004-2010 / Astra H) To replace the cabin fan on the Opel Astra, open the glove compartment located on the passenger side: once open, loosen the fastening bolts inside to…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos