Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Heating Resistor of an Opel Corsa

Model: Vauxhall Corsa Corsa D - Years 2006-2014
Part: Heater control valve

The heating resistor for the cabin is located at the back of the glove compartment. To begin, sit in the front passenger seat of your Opel Corsa. Start by disconnecting the electrical connector of the resistor by gently pulling it downwards. Once this step is complete, free and remove the resistor from its housing, finishing the disassembly. To install the new heating resistor, simply reverse these instructions, successfully completing the replacement.

Updated on 4 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Where is the Heating Resistor Located in the Opel Corsa?
Where is the Heating Resistor Located in the Opel Corsa?
Vauxhall Corsa (2006-2014 / Corsa D) In this video, you can see where the heating resistor is located in the Opel Corsa, useful in case you need to replace it due to a fault. As shown, t…
How to Replace the Heating Resistor of an Opel Corsa?
How to Replace the Heating Resistor of an Opel Corsa?
Vauxhall Corsa (2006-2014 / Corsa D) Before you begin, sit in the front passenger seat of your Opel Corsa. The heating resistor is located under the glove compartment. Start by disconnec…
Removing the External Temperature Sensor from an Opel Corsa
Removing the External Temperature Sensor from an Opel Corsa
Vauxhall Corsa (2000-2006 / Corsa C) In this video tutorial, you will see the main steps to remove the external temperature sensor from an Opel Corsa C. This part is replaced when it can…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos