Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the CV Joint on the Peugeot 307?

Model: Peugeot 307 MK 1 - Years: 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009
Part: Checks and maintenance

Video tutorial

To replace the CV joint on the Peugeot 307, first loosen the bolts that secure the wheel corresponding to the joint to be removed. Once the wheel is removed, you can access the rubber cover around the joint, which must be completely pulled off to access the joint.

The joint should then be disconnected from the remaining part of the driveshaft, allowing it to be replaced with a new part. After the new joint is installed, you can insert the new part and reassemble all removed components.


Updated on 15 June 2026 by ScegliAuto


Related tutorials

How to Replace the Front Wheel Bearing on a Peugeot 307
How to Replace the Front Wheel Bearing on a Peugeot 307
Peugeot 307 (2001-2009 / MK 1) To replace the front wheel bearing on a Peugeot 307, lift the vehicle with a jack and secure it with axle stands. Remove the wheel and unscrew the ce…
Replacing the front wipers of the Peugeot 307
Replacing the front wipers of the Peugeot 307
Peugeot 307 (2001-2009 / MK 1) Today's procedure will show you how to dismantle and replace the front wipers of the Peugeot 307, following the instructions below. First, open the b…
Where is the fuse box located in the Peugeot 307
Where is the fuse box located in the Peugeot 307
Peugeot 307 (2001-2009 / MK 1) To find the fuse box in your Peugeot 307, follow the steps outlined in this guide. First, open the glove compartment on the passenger side and locate…

    Frequently Asked Questions

    • 307 2001-2009 - Where is the oil pressure sensor located on the Peugeot 307? Read answer

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos