Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 207
    4. : Replacement of the high beam bulb of the Peugeot 207.

Peugeot 207 - Video tutorial

Model: Peugeot 207 MK 1 - Years 2006-2015
Part: Headlight bulb
Operation: Replacement of the high beam bulb of the Peugeot 207.

If we notice that the high beam bulb of our Peugeot 207 is burnt out, it is necessary to replace it as soon as possible. We open the engine hood and secure it with the appropriate rod. If the bulb to be replaced is on the driver's side, access is quite easy, but if it is on the passenger side, we need to detach and remove the windshield washer reservoir neck to access it. The bulb to be changed is the one at the bottom of the headlight, protected by a cap that we will remove by rotating it. Now we disconnect the electrical connector and remove the bulb after releasing the spring clip. We insert the new bulb, secure it with the clip, restore the electrical connection, close the protective cap, and check its proper functioning.


Posted on 20 September 2023 by ScegliAuto

    Frequently Asked Questions

    • 207 2006-2015 - How much does the Peugeot 207 low beam cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos