Do it yourself
| ||||
|
Peugeot 207 - Video tutorial
Model: Peugeot 207
MK 1
- Years 2006-2015 To remove the windshield washer fuse in the Peugeot 207, follow these steps: Make sure the car is turned off and the key is removed from the ignition to avoid short circuits or injuries. Locate the fuse box. In the Peugeot 207, the fuse box is usually located in the engine compartment or in the cabin. Refer to the owner's manual or the fuse box cover to identify the specific windshield washer fuse. There will typically be a diagram indicating the location and function of each fuse. Once you have located the windshield washer fuse, use a flat-nose pliers or a fuse puller to firmly grip it. Apply slight downward pressure and pull the fuse out of its slot. Make sure to keep it straight to avoid bending or damaging it. Visually inspect the fuse to check if it is burnt out. A burnt out fuse will have a broken internal filament or will be dark and opaque. If the fuse is burnt out, replace it with a new fuse of the same amperage. Make sure to use the correct spare fuse to avoid damage to the electrical system. Insert the new fuse into the corresponding slot, making sure to align the terminals correctly. Ensure the fuse is securely in place and fully inserted into its slot. Close the fuse box securely and make sure it is properly sealed.
Posted on 2 March 2024 by ScegliAuto
Other guides that may interest you
|
Replace the steering angle sensor on the Volkswagen Golf 5When the steering angle sensor malfunction warning light comes on, it may need to be replaced as follows: first remove the steering wheel and the lower steering wheel guard by removing the three fixing screws. The steering sensor is located just below the steering column. To release it you need to have a small screwdriver and insert it into the hole on the front, push the screwdriver all the way down until the clips at the bottom are released. Next, pull down on the back of the card containing the sensor and disengage it from the steering column. At that point take the new card and reposition it, after which proceed backwards to reassemble the various components. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.091
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |