Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 206
    4. : How to change the engine oil and filter of the Peugeot 206 2.0 Hdi

Peugeot 206 - Video tutorial

Model: Peugeot 206 MK 1 - Years 1998-2012
Part: Engine oil
Operation: How to change the engine oil and filter of the Peugeot 206 2.0 Hdi

The replacement of the engine oil and the relative filter is the classic do-it-yourself maintenance but it is recommended to take care to dispose of the waste correctly in the appropriate collection centers; then start by accessing the lower part of the engine to unscrew the oil drain plug located in the rear part of the sump, in the central position; once the drain is complete, screw the cap back on by applying a new copper or aluminum washer; then intercept the oil filter located next to the battery housing by unscrewing it with the special clamp wrench; apply oil to the gasket of the new filter by screwing it in manually and then fill the engine with clean oil up to the maximum level.


Posted on 24 September 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 206 1998-2012 - How much engine oil to pour into Peugeot 206? Read Answer
    • 206 1998-2012 - How much engine oil is needed in a Peugeot 206? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos