|
Do it yourself
| |||
| ||||
How to change the gearbox oil on the Renault Clio
Model: Renault Clio
Clio IV, MK 4, Clio 4
- Years 2012-2019
Today, you will learn how to independently change the gearbox oil on the Renault Clio IV. Start the replacement by opening the front bonnet and removing the breather cap, into which you should insert a small funnel. Before replacing the oil, pour a pre-change cleaner into the breather. Replace the cap on the breather and let the vehicle run for 10/15 minutes with the engine at idle. To change the gearbox oil, lift the front of the vehicle and remove the left front wheel. Remove the plastic cover of the engine by unscrewing the bolt with a 30mm Torx key and a ratchet with a 10mm socket. With the help of a square key, unscrew the drain plug and let the oil drain into a previously positioned container. Allow the fluid to drain into the container for a few minutes and replace the drain seal with a new one. Tighten the tank bolt and unscrew the filling cap located on the driver's side. Use a plastic tube to pour the oil into the tank. Once the tank is filled, screw on the white plastic cap. Reposition the cover and lower the vehicle.
Posted on 14 April 2026 by ScegliAuto
Video tutorial
Related tutorials
Renault Clio
(2005-2013 /
MK 3, Clio 3, Clio III)
To change the gearbox oil on a Renault Clio, raise the car to gain easier access to the components underneath the engine compartment. Locate the gear…
Renault Clio
(2005-2013 /
MK 3, Clio 3, Clio III)
To replace the gear oil on a Renault Clio, lift the car using a ramp or jack to remove the plastic cover of the lower components by loosening the app…
Renault Clio
(1998-2005 /
Clio 2, MK 2)
As a fundamental preliminary operation, you must lift your vehicle and place it on appropriate stands. Next, release and lift the bonnet to gain bett…
Other guides you may be interested in
|
How to Repair the Key Spring of the Peugeot 207?
Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.273
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |