Do it yourself
Frequently asked questions about cars and motorcycles

A Common Problem with the Right Rear Window Regulator on the Renault Scenic II

Model: Renault Scenic Scenic 2, MK 2 - Years: 2003, 2004, 2005, 2006, 2007, 2008, 2009
Part: Side window

See other generations:
Video tutorial

This video shows a common problem with the Scenic II (and also the Megane II) that often frustrates less experienced mechanics: the right rear window regulator and the electronic handbrake do not work. The cause is due to rainwater accumulating in the glove compartment under the driver's side mat (in front of the front passenger seat); this compartment is not adequately drained and forms a sort of pool, flooding the electrical components located beneath it, such as the double connector of the relay group, the wires, and the module of the electric handbrake relay group.

You will need to remove the front seat, lift the carpet to access the flooded compartment, clean the drainage holes (or create new ones), visually locate the handbrake relay group and the large double connector, to check that the pins are not corroded.

The solution shown for repair is a direct bypass; the damaged wires are cut, new wires are soldered to bypass the broken connector, and each solder joint is protected with heat-shrink tubing for insulation.

The functionality of the window regulators and the handbrake will be restored.


Posted on 17 April 2026 by ScegliAuto


Related tutorials

Renault Scenic (2003-2009 / Scenic 2, MK 2) In this short guide, we will see the instructions that will allow us to reset the window motor of the Renault Scenic, performing its recalibration. F…
Renault Scenic (2016-2022 / Scenic IV, Scenic 4, MK IV, MK 4) Repairing the window switch on a Renault Scenic may seem difficult, but it can actually be done independently, especially with the help of our video …
Renault Scenic (2016-2022 / Scenic IV, Scenic 4, MK IV, MK 4) To manually release the electronic handbrake of the Renault Scenic, there is a procedure that can be performed: you will need to access the lower par…

Other guides you may be interested in

How to Remove the Toll Tag Holder from the Car Windscreen

The toll tag holder is usually attached to the car windscreen to ensure that the toll tag functions immediately when passing through barriers. However, if you decide to remove the holder, you should follow this procedure: - Insert the toll tag into the holder; - Pull the holder inwards to detach it from the windscreen; you can use a glass scraper or a stiff plastic card to assist you; After removing the holder, it is essential to remove the adhesive from the windscreen. To remove the adhesive, we recommend using a solvent-based spray that will remove the glue without clouding the area.

Watch the video!


by ScegliAuto

More videos