How to Change the Engine Oil and Filter on the Renault Scénic

On the Renault Scénic, change the oil and filter safely with the car on level ground, handbrake engaged, and the engine warm (not hot). If you need to lift the vehicle, use jack stands and the correct lifting points, as you will be working under the engine. Prepare a collection tray, gloves, rags, a sump plug spanner, and the tool for the oil filter. Open the bonnet of the Renault Scénic and unscrew the oil filler cap: this helps the oil drain better. Position the tray under the vehicle and unscrew the sump drain plug, allowing the oil to drain until the flow becomes minimal. Meanwhile, locate the oil filter on the Renault Scénic and remove it with the appropriate spanner, being careful of any residual oil. Before installing the new filter, check that the old gasket is not stuck to the seat. Lightly lubricate the new filter gasket with a thin layer of oil and screw it on until it is snug, then tighten without overdoing it. Refit the drain plug with its washer/seal if required and close it properly. At this point, top up the oil in the Renault Scénic with the correct specification for your engine (grade and quantity may vary based on engine code and trim, so refer to the manual). Start the engine for a few seconds, turn it off, and immediately check for any leaks around the sump plug and filter. Wait a couple of minutes and check the level with the dipstick, ensuring it is between the minimum and maximum without exceeding the level.