Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Injectors on the Renault Clio

Model: Renault Clio Clio 3, MK 3, Clio III - Years: 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013
Part: Fuel injectors

See other generations:
Video tutorial

This guide shows how to replace the injectors on the Renault Clio 182. After opening the engine bay, locate the injector block; it is situated on the front side of the vehicle, protected by a plastic cover. Disconnect the fuel line by applying some force and the connectors of the individual injectors.

Using a hex key, unscrew the retaining bolts of the block, and with a bit of patience, you can slide out the old injector block. At this stage, the injectors may remain in place, so simply pull them out one by one before fitting the new ones.

You can now reconnect the wires, the retaining bolts of the block, and finally the fuel line. By performing a few ignition cycles, you will allow the fuel to circulate through the new part.

Leave the engine running for a few minutes to stabilise the fuel flow.


Updated on 15 April 2026 by ScegliAuto


Related tutorials

How to Test and Replace Faulty Injectors on a Renault Clio
How to Test and Replace Faulty Injectors on a Renault Clio
Renault Clio (1998-2005 / MK 2, Clio 2) To test the injectors on a Renault Clio, open the bonnet and loosen the high-pressure connectors, then activate the starter motor. Tighten the connec…
How to Replace the Injectors on the Renault Clio 1.5 DCI
How to Replace the Injectors on the Renault Clio 1.5 DCI
Renault Clio (1998-2005 / MK 2, Clio 2) Today, we will see in this video tutorial the steps to remove and replace the diesel injectors on the Renault Clio 1.5 DCI. First, open the bonnet an…
Check the pin-out of the fuel pump control relay of the Renault Clio 1.8 16V.
Check the pin-out of the fuel pump control relay of the Renault Clio 1.8 16V.
Renault Clio (1998-2005 / MK 2, Clio 2) In this video we see the PIN OUT, that is the arrangement and function of each individual contact (pin) present on an electrical connector. In this c…

How to Reset the Tyre Pressure Warning Light on the Jeep Renegade?

To reset the tyre pressure warning light on the Jeep Renegade, inflate the tyres until they reach the recommended pressure: this value is indicated on the sticker attached to the driver’s door pillar. Once the tyres are properly inflated, navigate through the menu that appears on the instrument cluster until you find the tyre pressure option. At this point, press and hold the OK button on the right side of the steering wheel to make the warning light disappear.

Watch the video!


by ScegliAuto

More videos