Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of the Steering Rack Axial Joint

Model: Renault Megane Megane 2 - Years: 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010
Part: Control arm

See other generations:
Video tutorial

To replace the axial joint (commonly known as the tie rod) of the steering rack, raise the vehicle on suitable axle stands and remove the front wheel. Before removing the ball joint, loosen the locking nut on the axial joint itself.

Then, unscrew the fastening nut of the ball joint, pull it out from the hub support, and unscrew it from the tie rod, counting the number of turns. At this point, remove the retaining clips of the gaiter and unscrew the tie rod from the rack, taking care of the plastic washer.

Screw in the new tie rod, insert the gaiter securing it with the respective clips, and screw the ball joint back in the same number of turns. At the end of the installation, it is advisable to check the alignment on a suitable test bench, but preliminarily, you can also check the wheel alignment using a piece of string as shown in the video.


Updated on 17 February 2026 by ScegliAuto


Related tutorials

Front Hub Bearing Replacement
Front Hub Bearing Replacement
Renault Megane (1995-2003 / Megane 1) To replace the front hub bearing, you need to remove the hub itself, disconnecting everything attached to it: suspension wishbone, driveshaft, steeri…
How to Replace the CV Joint on the Renault Megane
How to Replace the CV Joint on the Renault Megane
Renault Megane (1995-2003 / Megane 1) This guide shows how to replace the CV joint on the Renault Megane. Mechanical knowledge is required for this replacement. The first step is to remov…
Drive Shaft Gaiter Replacement Instructions
Drive Shaft Gaiter Replacement Instructions
Renault Megane (1995-2003 / Megane 1) This system allows you to replace the drive shaft gaiter without disassembling the CV joint: however, you need to extract the drive shaft from the hu…

How to Open the Fuel Filler Flap in the Hyundai i30?

In this tutorial, you will learn how to open the fuel filler flap in the Hyundai i30, a very simple operation that follows the typical procedure of most vehicles. First, unlock the locks using the designated button on the remote, then open the driver's door, locate the release lever on the left side of the seat, and operate it. Next, move to the fuel filler flap, open it completely, unscrew the cap, and refuel as needed. To close the flap, simply press it gently.

Watch the video!


by ScegliAuto

More videos