Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Renault
    3. :
  3. Clio
    4. : Replacement of anti-roll bar bushing

Renault Clio - Video tutorial

Model: Renault Clio Clio 2, MK 2 - Years 1998-2005
Part: Anti roll bar
Operation: Replacement of anti-roll bar bushing

If you hear some noise coming from the front end and the road holding seems to have worsened, it is likely that some bushings supporting the suspension oscillating arm may have failed; lifting the car on special car stands and removing the front wheel, you notice the failure of the support bushing of the anti-roll bar: then unscrew the fixing pin of the bushing which is actually made up of three pieces, extract the lower and upper ones and lever between the swinging arm and the bar to create the right space and extract the third bushing; then insert the new ones and secure them with the relative pin.


Posted on 1 September 2023 by ScegliAuto



How to remove the front arm bushing of a Renault Clio
Renault Clio (1998-2005 / Clio 2, MK 2) Let's see how to remove the front arm bushing of a Renault Clio. First of all we put the car on a bridge: we raise the car to a preferred height and
How to disassemble the front shock absorbers in Renault Clio?
Renault Clio (2012-2019 / Clio IV, Clio 4, MK 4) In this tutorial we can see how to disassemble the front shock absorbers on the Renault Clio, a simple operation that requires good manual skills. Fi
How to replace the gearbox bushing on the Renault Clio?
Renault Clio (1998-2005 / Clio 2, MK 2) In order to replace the Renault Clio gearbox bushing, it is necessary to lift the car with a jack or using a bridge to be able to act on the componen

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos