Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Renault
    3. :
  3. Clio
    4. : Replacement of the alternator of a Renault Clio 4.

Renault Clio - Video tutorial

Model: Renault Clio MK 4, Clio IV, Clio 4 - Years 2012-2019
Part: Alternator
Operation: Replacement of the alternator of a Renault Clio 4.

In this very useful video tutorial today, you will be able to see the entire procedure necessary to replace the alternator on a Renault Clio, fourth generation model produced from 2012 to 2019. So the first thing to do is to remove the alternator belt. To do this, we need to remove the right front wheel and the plastic protection to reach the pulley, loosen it, and remove the belt as shown in the tutorial. Once this is done, we can disconnect the connectors of the old alternator and then remove it by unscrewing the screws that hold it in place. Finally, we install a new alternator following the reverse procedure.


Posted on 13 February 2024 by ScegliAuto

    Frequently Asked Questions

    • Clio 1998-2005 - How do you change the alternator on a Renault Clio 2? Read Answer
    • Clio 2005-2013 - Where is the alternator of the Renault Clio located? Read Answer
    • Clio 2012-2019 - How much does the Renault Clio 4 alternator cost? Read Answer
    • Clio 1990-1998 - How much does the alternator cost of a Renault Clio? Read Answer
    • Clio 2005-2013 - How much does the alternator cost of a Renault Clio? Read Answer
    • Clio 1998-2005 - Where is the Renault Clio alternator located? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos