Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Seat
    3. :
  3. Ibiza
    4. : How to replace the headlight bulb on a Seat Ibiza

Seat Ibiza - Video tutorial

Model: Seat Ibiza 6P, 6J - Years 2008-2017
Part: Headlight bulb
Operation: How to replace the headlight bulb on a Seat Ibiza

Before we can start, we will have to go and open the front hood of our Seat Ibiza. So let's start by unhooking the clip that secures the rear cover of the burned out light bulb, and then extract and remove the cover itself. After that, we will have to go and disconnect the relative power plug, and then release the clip that holds the bulb in place. By doing so, we will have freed the burned out light bulb. We then proceed by going to extract it from its housing, and we will have finished the disassembly. To fit the new bulb, we will just have to follow these steps in reverse, and we will have completed the replacement.


Posted on 26 January 2024 by ScegliAuto



How to replace the front headlight bulb of the Seat Ibiza.
Seat Ibiza (2008-2017 / 6P, 6J) This short guide will show you the steps on how to disassemble and replace the headlight bulb of the Seat Ibiza. First, we open the engine hood of ou
How do you replace the front headlight bulb of a Seat Ibiza?
Seat Ibiza (2008-2017 / 6P, 6J) Replacing the headlight bulb of the Seat Ibiza is done by opening the hood, so that access to the cover located inside the headlight can be obtained:
How to replace the front headlight bulb of the Seat Ibiza.
Seat Ibiza (2002-2009 / 6L) The instructions we will see will allow us to disassemble and replace the front headlight bulb of the Seat Ibiza. First, we open the vehicle's engine

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos