|
Do it yourself
| |||
| ||||
How do I remove the door panel of the Smart 450?
Model: Smart Smart
450
- Years 1998-2007
In order to remove the internal door panel of the Smart 450 you have to remove the triangular cover in correspondence with the external rearview mirror. Once removed, you will have to unscrew the screws below and remove the mirror; then you can unscrew the screw in correspondence with the external door handle and remove the latter as well. This will make it possible to detach the outer door panel and remove the actuator underneath. Then, by unscrewing the special screws on the internal skeleton of the door and the other screws remaining in the internal panel, it will be possible to detach the latter and replace it with a new spare part.
Posted on 18 December 2021 by ScegliAuto
Video tutorial
Related tutorials
Smart
(1998-2007 /
450)
The removal of the external door panel of the Smart 450 is carried out by opening the door and removing the side cover in correspondence with the han…
Smart
(1998-2007 /
450)
The removal of the door panel on the Smart 450 is done by unscrewing the screws that secure the storage compartment located at the bottom left of the…
Smart
(1998-2007 /
450)
In order to remove the external door panel of the Smart 450, it is necessary to pry into the seat of the external handle, so that it can be completel…
Other guides you may be interested in
|
Frequently Asked QuestionsHow to Replace the Front Headlamp Bulb on a Fiat Grande Punto
To replace the front headlamp bulb on a Fiat Grande Punto, first open the bonnet. Once done, access the rear of the headlamp where the bulb needs replacing (the bulb is of type H4). Locate the rubber cover that protects the electrical contacts and bulbs from water and moisture. Remove it by pulling on the tab. Now, pull the connector for the bulb's power supply and disconnect it from its position. At this point, push down on the top of the spring that holds the bulb in place, and you can extract the bulb from its housing. To fit the new bulb, follow the steps in reverse as shown in the images. The video also shows how to remove the position bulb, which is located just below the H4. After disconnecting the power supply, you can extract it along with the bulb holder by pressing the two tabs to release it and pulling. The bulb can then be removed from its position in the bulb holder. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.058
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
